How to replacement the IPHONE 6 Plus LCD screen

- Dec 23, 2017 -


  • Before disassembling your iPhone, discharge the battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

  • Power off your iPhone before beginning disassembly.

  • Remove the two 3.6 mm P2 Pentalobe screws next to the Lightning connector.

image.png

  • If you don't have an iSclack, use a single suction cup to lift the front panel:

  • Press a suction cup onto the screen, just above the home button.

  • Be sure the cup is pressed securely onto the screen to get a tight seal.

  • image.png

  • While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the front panel assembly from the rear case.

    • Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices.

  • Using a plastic opening tool, begin to gently pry the rear case down, away from the display assembly, while continuing to pull up with the suction cup.

  • There are several clips attaching the front panel assembly to the rear case, so you may need to use a combination of the suction cup and plastic opening tool to free the front panel assembly.

  • image.png

Remove the following Phillips screws from the battery connector bracket:

  • One 2.3 mm screw

  • One 3.1 mm screw

                              image.png

  • While holding the front panel open at about a 90º angle, remove the following Phillips screws securing the front panel assembly cable bracket:

    • Three 1.2 mm screws

    • One 1.5 mm screw

    • One 2.9 mm screw

  • Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board

image.png

image.png

Remove the two 1.8 mm Phillips #00 screws securing the home button bracket to the front panel.

image.png

image.png

Previous:Apple Battery with Large capacitance 2245mAh Next:What is In-cell Phone LCD?